Designed and built to install and remove the pressed bearing used on Campagnolo® and Fulcrum® Ultra-Torque cranks
This tool is designed to remove the non-threaded bottom bracket bearings of the BB30 bottom bracket system
The Screw type chain tool is intended for both professionals and home users
To use, put the wrench into the bottom bracket nut, so that the screw is inserted into the bottom bracket
The vice features two different diameter receptacles of 9 mm and 10 mm for inserting front or rear axles
The tool is used for repairing minor damage on the front sprocket
The sprocket wear indicator is used to determine the condition rear sprockets. It can be used to check 12 to 21 tooth sprockets
The freewheel remover is designed for removal of single speed freewheels, which are broader than multi speed freewheels
To use, put the wrench onto the bottom bracket nut, so that the screw is inserted into the bottom bracket.
To use, put the wrench onto the bottom bracket nut, so that the screw is inserted into the bottom bracket
This crank puller is used to remove cranks with damaged inner thread, when the crank can not be removed with a normal crank puller
The crank puller is used for removing new XTR cranks.
The wrench is used for installing and removing of older bottom brackets
Wrench for rear sprocket with handle is used for Shimano®, SRAM®, Sun Race®, Suntour® and other cassette sprockets, like the key nr. 1670.7
The wrench is used for unscrewing and tightening of front sprocket nuts
The tool is easy to use and very precise. It is used to check the parallelism between the transmission bracket and the wheel, and to align the bracket if the parallelism is not reached